TimberCraft Wood Works

10/25/2025

Finished this Walnut dining table. It is 7ft. long and extends to 9 with a butterfly leaf in the center. The customer supplied the 30 year old 8/4 walnut & the sewing machine bases!!! I finished it with 2 coats of sanding sealer then 2 coats of spray on Lacquer!!

07/23/2024

05/10/2023

I made a few new cabinets for Amy’s craft room. It was a mixture of all sorts of things and she really wanted to organize better! I made each one to suit her particular needs & wants. Special thanks to son Taylin for doing the bulk of the install and wife Nancy for helping with paint & sharing her critical eye! Also big thanks to Amy for her patience. By the way, Amy makes greeting cards of all sorts for Cards By Amy

05/10/2023

The builder put up a very generic mantel when house was built. My daughter-in law wanted something a little different so here is what she wanted!

10/15/2022

Lone Spur Cafe in Silverton Co. The likes of Wyatt Earp & Doc Holliday have bellied up to this very bar!!

10/15/2022

Aspens at full color! San Juan National Forest!!!!!

10/13/2022

Standing on a corner in Winslow Az. Oh wait Durango Co. My bad!!!!🤪🤪

07/10/2022

Nancy, Taylin, & I installed this storage cabinet & two, three inch thick floating shelves for a client. Cabinet top & shelves are made of red oak with Old Masters dark walnut stain to match the existing kitchen cabinets!

05/06/2022

Built a couple new cabinets for a bathroom, one full height with upper storage & 3 drawers below and one upper unit with storage shelves

11/05/2021

I took two butcher block tops, ripped one down in width and the other I cut into two pcs. I jointed the edges that would glue together to make the top to surround this stove

10/05/2021

We installed the table today with the help of the clients. At 4 x 10 feet the top alone was over 300lbs. Made from mostly red oak out of old floor joists from a family barn. The only screws used in this build were for the table clips holding the top in place, otherwise the joints are half lap joints with 1/2” glue pins. The finish is 3 coats of Teak Oil, sanded with 600 grit between coats then a final buff using 0000 steel wool