Dane-Everett Engineering

Dane-Everett Engineering Van Builder, Solar Energy Power Systems, Mobile Electrical & Electronics

I don't like MondaysI have known about sort of really, REALLY needing to replace the front strut cartridges in my van ...
08/25/2026

I don't like Mondays

I have known about sort of really, REALLY needing to replace the front strut cartridges in my van for a while now but I suppose that I will be doing the brakes as well... Just another one of those things that keep life interesting.

It's not like building a house - The three main factors that make building a van uniquely complex1. Nothing is level, no...
08/12/2026

It's not like building a house - The three main factors that make building a van uniquely complex

1. Nothing is level, nothing is square, and nothing is straight, so you can leave the level and the plum bob at home.

The trick is to mark a centerline right down the middle of the floor and the ceiling of the van EVERYTHING will be measured and square up from the floor and out (or in) to the center lines.

2. Weight and weight distribution

Weight, It all adds up quick. It doesn't take very much before you hit that magic mark of over MGVW but that's not all. It is not only how much weight you put in a van that gets you, where you put it can be critically dangerous...

Carrying weight high in a van (upper cabinets, rooftop equipment and gear) can make a van seriously unstable steering and sway right up to the point of flipping on its side. Carrying too much weight too far back can affect steering response due to changes in the steering geometry as well as the back of the van coming around on slick road conditions... It can also greatly negatively impact braking performance under any road conditions.

And then there are the less critical consequences, take my own van for example a 2018 Ford Transit 350 high top. As an empty cargo van I averaged 18 to 20 miles per gallon. As a Home/Office/Work Truck I get a mixed average of 13 1/2 miles to the gallon... And boy does this thing hate climbing hills especially when I'm loaded down with a garage full of tools (which puts it right at Max Gross vehicle weight of 9500 pounds)

3. Nothing inside of the can is solid or stationary

Depending on attitude, temperature, and load everything moves and twists around a substantial amount... this is why most built out vans pop, creak, and eventually fail because something breaks or breaks loose from the van's metal structure.

The only sensible way to deal with this situation is to allow for the flex (let it move), rather than framing, furring or battening the entire interior of the can building it in sections with joints that allow for slip (my preferred way is to insulate them from each other with felt stripping) but even then...
.. One additional point that I would like to make is that generally a house built on a slab isn't going to ever have a 65 mile an hour collision... keep that in mind when you're building out your van. PRO tip frame anchored steel cable run over strategically placed plates can save you from having to occupy the driver seat along with 1/2 of a ton of lumber and all of your belongings)

  🙄... I should've known better.You just don't see something like this on a Sprinter or a Transit.None of these things a...
08/06/2026

🙄... I should've known better.

You just don't see something like this on a Sprinter or a Transit.

None of these things are really intended for what we're doing to them but because the ProMaster is a front wheel drive it is not necessary for them to have all of the heavy structure to transmit power from the rear axle subsequently the only real solid stuff back here is the belt line, the floor, and the C pillar behind the door.

Pretty much every place else you attached to the structure needs to be back plated.

So... Trying out the little Ninja Crispy air fryer for the first time. Pulls down about 30 W more than our little micro...
08/04/2026

So...

Trying out the little Ninja Crispy air fryer for the first time. Pulls down about 30 W more than our little microwave, so that's pretty good, the system can easily handle it. and it packs away pretty small and not too terribly heavy even considering the container is glass. So far I could easily recommend it for

And no, nobody is paying me to say this.

I used to think that it was strange to live in a van but now, some years down the road, I ponder what it would be like (...
07/23/2026

I used to think that it was strange to live in a van but now, some years down the road, I ponder what it would be like (especially lately) to go back to living in a house or an apartment and I can't even wrap my head around it.

A few months ago I was in the middle of remodeling the "kitchen" in my Ford Transit (moving everything from one side of ...
07/18/2026

A few months ago I was in the middle of remodeling the "kitchen" in my Ford Transit (moving everything from one side of the van to the other... Again) when a young couple came walking by and asked me if I knew anything about van solar power, electrical etc.

Here we are a few months down the road, and my two young clients have sent me a picture of our handiwork put to use.

Updated 1994 190 in the middle of nowhere. 600 W of solar, Orion XS DC to DC, 570 amp hours of storage, 3000 W inverter, 12 V compressor refrigerator, induction cooktop, and the cutest little air fryer I've ever seen (so cute my wife had to have one too) 



Now we are down to re-sizing/fitting a mattress, fabricating a couple of weird little rollout mechanisms, and a metric/e...
07/10/2026

Now we are down to re-sizing/fitting a mattress, fabricating a couple of weird little rollout mechanisms, and a metric/eff ton of trim.

the job that almost but didn't quite kick my ass.

Simple, but kind of tedious work, installing flooring AND defrosting the refrigerator...
07/07/2026

Simple, but kind of tedious work, installing flooring AND defrosting the refrigerator...

I look around in here and it's kind of like London during the Blitz, but when it got down to the spot where the old wate...
07/07/2026

I look around in here and it's kind of like London during the Blitz, but when it got down to the spot where the old water pump used to live I shove the new water pump/accumulator in and surprise it fits 😳 ... So there's that.

Re-fitting an old is kind of insane, and taking a couple of kids through it that don't really have any engineering/mechanical experience is like hearding cats  but everything about it's kind of like that (insane, but I love it.)

At any rate batteries are in, power and ground supply side is in, DC to DC charging is in there and working (Victron Orion XS) fan is hooked up, USB chargers are hooked up, inverter and remote installed and ready to operate a tiny air fryer, heater blankets, and induction top... so yeah, something got done.

Address

Unit 1092
Ventura, CA
93002

Opening Hours

Tuesday 9am - 5pm
Wednesday 9am - 5pm
Thursday 9am - 5pm
Friday 9am - 5pm
Saturday 9am - 5pm

Website

Alerts

Be the first to know and let us send you an email when Dane-Everett Engineering posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Dane-Everett Engineering:

Shortcuts

Share