09/10/2026
⚡ One service call. Two electrical problems you definitely don’t want hiding in your home.
The original complaint was simple: a light wasn’t working.
After finding no power at the switch, we traced the circuit back to the junction box pictured. Inside, we found wire nuts wrapped in duct tape, a neutral conductor that had dropped completely out of the bundle from improper wire-nut securement, and multiple cables entering the metal box without proper protection.
We corrected the connections, properly secured the conductors, addressed the cable entries, and restored power to the light. ✅
But while we were there, we found another issue.
A separate bathroom light fixture flickering after a few minutes of being on and I noticed was getting EXTREMELY hot—the glass globe was still too hot to comfortably touch roughly 10 minutes after the light had been turned off.
The reason?
💡 A 200-watt bulb had been installed in a fixture rated for a maximum of 60 watts.
That’s more than 3× the fixture’s rated wattage.
Why does that matter?
The fixture was rated for a maximum 60W bulb because that’s the amount of heat its socket, wiring, and enclosure are designed to safely handle. A 200W bulb produces significantly more heat, which can damage wiring and the socket over time and create a potential fire hazard. In this case, the glass globe was still too hot where it burned me roughly 10 minutes after the light had been shut off
Electrical problems aren’t always a bad breaker or a light switch. Sometimes the real problem is buried in a junction box—or screwed into the fixture itself.
If something in your home isn’t working, keeps tripping, flickers, smells hot, or is running way hotter than it should, don’t ignore it!!! Better to have a service call than one with your insurance company.
Citadel Builders LLC
📞 (574) 529-1778
🌐 citadelbuilders.co
Trust the process. Build with faith.
Hebrews 3:4