SlipLab

SlipLab SlipLab provides third party slip testing services across Sydney and regional NSW.

We can determine compliance with the National Construction Codes (NCC) and Standards Australia Handbooks with NATA accredited wet pendulum and dry floor friction testing.

Testing pavement paint on ashpalt
20/08/2024

Testing pavement paint on ashpalt

Unfortunately, I didn’t bring my board shorts to this job
11/05/2022

Unfortunately, I didn’t bring my board shorts to this job

SA HB 198:2014 Table 3A applications and values have been determined by the Australian Building Codes Board for use in r...
16/11/2021

SA HB 198:2014

Table 3A applications and values have been determined by the Australian Building Codes Board for use in regulations based on the NCC.

Ramps in Buildings Covered by NCC Volumes One and Two

Ramps not steeper than 1:14 gradient (when wet)

Minimum wet pendulum classification deemed suitable P4

Getting ready for some on site AS 4586 testing in a Sydney CBD carpark.
08/09/2021

Getting ready for some on site AS 4586 testing in a Sydney CBD carpark.

Facilities accredited by NATA are recognised by the National Construction Code (NCC) to be Accredited Testing Laboratori...
30/08/2021

Facilities accredited by NATA are recognised by the National Construction Code (NCC) to be Accredited Testing Laboratories.

Deemed-to-Satisfy Solutions
For finishes such as carpet, tiles, slate, vinyl or rubber, where the product is consistent and does not vary considerably as part of the manufacturing process, a laboratory test may be appropriate. In this case, the supplier or manufacturer will have the necessary slip-resistance information and test reports to show that their product has been tested in accordance with AS 4586.

Alternatively, an in-situ test can be conducted using the wet pendulum test as described in AS 4586, or a compliant tested nosing strip could be attached to the treads and landings.
For timber surfaces, where the manufacturer uses pre-coated finishes, they could have these variants pre-tested to AS 4586. Alternatively a compliant tested nosing strip could be attached to the treads and landings.

SlipLab is accredited by the National Association of Testing Authorities Australia (NATA) following demonstration of its...
30/08/2021

SlipLab is accredited by the National Association of Testing Authorities Australia (NATA) following demonstration of its technical competence to operate in accordance with ISO/IEC 17025 2017. Our facility accreditation number is 20858.

We offer our clients
• Priority in situ testing for construction site handovers
• Professional, Reliable, Accurate Testing
• Quick turnaround for laboratory testing
• Easy to interpret reports.
• WE are located near Sydney CBD for fast service.

SlipLab provides third party slip testing services across Sydney and regional NSW, our easy to interpret impartial test ...
30/08/2021

SlipLab provides third party slip testing services across Sydney and regional NSW, our easy to interpret impartial test results can determine compliance with National Construction Codes (NCC) and Standards Australia Handbook 197 and 198.

SERVICES WE PROVIDE
• Onsite and Laboratory wet pendulum testing
• Onsite and Laboratory dry floor friction testing
• Programmed facility testing
• Facility pedestrian surface risk assessments

Address

PO Box 415
Mortdale, NSW
2223

Website

Alerts

Be the first to know and let us send you an email when SlipLab posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to SlipLab:

Shortcuts

Share

Category