Brabant Contracting

05/10/2026

Stage 1 down……2.5km of this 16km project.
Waiting game now for approval from both private and Government neighbours to give the go ahead.

03/10/2026

25/09/2026

What about this one!!!
GalMax Maxloc 19/183/5 horsemesh on 2.7m maxi posts with 900mm netting apron.
IA very cost effective security fence (this fence without the apron) is a much cheaper option than a traditional chainmesh fence.
Wire and posts supplied by Elders and strainers supplied by Metaland Inverell.
If your after fencing gear or steel for your projects give these guys a call

11/09/2026

**Ashford people please share**
We currently have our 100hp skid steer working in the area stick raking and cleaning small dams.
Machine is equipped with 2.5m stick rake, 4in1 bucket, 8ft slasher and augers from 100mm to 600mm that can dig holes to a depth of 2.4m
Give us a call on 0400896498 or send a message

05/09/2026

Good flood fence this one!!!!
Zoom in to see the wire above the bobcat……..and that fab fencer attachment is 2.4m high

30/08/2026

Got the old welder dialled in today!!
Swapped to a newer version (same brand) of gasless wire and couldn’t for the life of me run a decent bead……..managed to get hold of half a pallet of old stock and the results are night and day.
Welder: Weldclass Force 180MST
Wire: Cigweld Weldskill 0.9mm gasless

29/08/2026

Some intersting times ahead!!!!!
Back where I love working………..big hills and big rocks, always up for a challenge.
Dozer is benching in the fenceline just ahead of me as it’s too steep to safely negotiate the side slope with the bobcat let alone a vehicle.
THOR Rock Breakers & Post Drivers Australia doing a great job coupled to the remote control Bobcat in the steep stuff

10/08/2026

An all maxi fence makes a strong and long lasting statement, as well as looking good.
This is definitely an old school design with 4 selvedge wires on the mesh and an offset electric both sides to keep the bulls off the fence.

27/07/2026

Eyeball bandit at it again!!!! (I like that term whoever said it to me previously)
Rails - 22
Recuts - 2 (5mm too long)
Hit in with hammer - 1
Time - 4hrs
Men - 1
No clamps, no stringlines, no sliding bevels, no wasting time tracing out cuts, just good old fashioned know how.
All my employees get taught this way, upskilling every one of them so that they can complete the job with minimal tools necessary, because when your out in the scrub and your texta runs out or your coping gadget gets lost or broken, guess what????? You have the knowledge to finish the job.
This is also efficiency and efficiency is money!!!!