What are the opening hours?

Monday 7am - 5pm Tuesday 7am - 5pm Wednesday 7am - 5pm Thursday 7am - 5pm Friday 7am - 5pm

GoRenew

A specialist contract company with expertise in masonry structural repair.

27/02/2026

Arch Repairs at Tewantin, Queensland.

The Problem: The arch had cracked due to subsidence in the area caused by trees too close to the house.

The Solution: First we braced the arch to keep it in place. We then installed our Rapid Set GoBar system which fully cures within 30 minutes. We then repointed using colour match mortar to match existing. We were able to take the prop away the same day using this method.

24/02/2026

Underpinning at Sunnybank Hills, Queensland.

The Problem: The concrete foundation for the brick fence was less than 300mm deep causing the brick fence to subside. There is a power box near by so the builder chose not to go the full depth with the foundation.

The Solution: First we located the power so we knew where to avoid, it went straight under the pillar near the power box. Next we used lateral force to push the fence back to its original position. We then dug 600mm down and underneath the concrete foundation, we managed to get pretty close to the pillar with no disturbance. We then added reinforcing steel boxes for strength and filled the holes with concrete.

30/01/2026

Pillar Repairs at Sinnamon Park, Queensland.

The Problem: The affected pillar had been hit by a car and unfortunately was too far gone for us to repair.

The Solution: We dismantled the pillar by removing each brick and individually cleaning. The cracked bricks were replaced with ones that match the existing. We went down to the concrete foundation which was still in excellent condition. Once the area was prepared we laid the bricks to match the existing and finished with a pier cap on top. The finish is a bagged rendered look hence the messy repointing. Once painted the pillar will blend in perfectly with the existing brickwork.

09/01/2026

Leaning Fence Repairs at Auchenflower, Queensland.

The Problem: The block fence had not been core filled when built and invasive trees and bushes were planted too close. The fence was literally hanging on with just a single bracket anchored to one side of the hollow block fence.

The Solution: First we used our acroprops to brace the affected areas, next we cut the bracket and used lateral force to push the affected areas back to their original position. We installed our GoBar system to reconnect and reinforce the affected areas. To finish we patch rendered the affected areas to match existing.

31/12/2025

Brickwork Repairs at Redland Bay, Queensland.

The Problem: We believe the mortar between the bricks had broken down due excessive water flowing into the affected area. This is most likely caused by poor drainage and water rising up through the brickwork.

The Solution: We removed all the loose bricks and cleaned them up. We also cleaned up the affected area before relaying the same bricks with colour matched mortar to match existing.b

17/10/2025

Brick Repairs at Samford Valley, Queensland
The Problem: The rebar inside the pillars had corroded, which expanded and cracked/blew the bricks off.
The Solution: First we propped all corners of each pillar. Next we removed all the damaged bricks and rebar. We then rebuilt the pillars using bricks provided by the customer, these bricks are now discontinued and they got the closest match possible. We installed our GoBar system from top to bottom of each pillar to reinforce. To finish we repointed with colour matched mortar to match existing.

20/09/2025

Leaning Fence Repairs at Runaway Bay, Queensland

The Problem: Golden Cane Trees planted too close to the fence causing it to subside 90mm.

The Solution: We applied lateral force onto the affected fence, pushing back to its original position. Next we installed our GoBar system to reconnect and reinforce the affected areas. To finish we repointed the cracked mortar to match existing.

14/09/2025

Mortar Repairs at New Farm, Queensland.

The Problem: The 100+ year old chimney was in need of some mortar repair as the mortar had deteriorated over the last 100 years. The mortar had broken down that much that sand was forever falling out and its structural integrity was compromised.

The Solution: We first sheeted the floors and walls in the affected areas to seal off the rooms. Next we cut out all the affected mortar and throughly cleaned ready to repoint. The finish we used colour matched mortar and repointed to match existing.

05/08/2025

Brick Arch Repair at Sherwood, Queensland

The Problem: Subsidence caused the brick arch to fail.

The Solution: We propped the arch to take the weight of the brickwork. Next we cut out it the existing mortar in the affected area and applied pressure, pushing the affected area back to its original position. After this we installed our GoBar system to reconnect and reinforce the affected area. To finish we repointed/repaired the affected area with colour matched mortar.

26/07/2025

Brick and Mortar Repairs at Wellington Point, Queensland.

The Problem: Rising damp caused the face of the bricks to deteriorate and also deteriorated the mortar.

The Solution: We cut out the affected bricks and replaced them with the original spare bricks the customer had. We cut out any loose or missing mortar and repointed with colour matched mortar to match existing.

20/07/2025

Pillar Rebuild at Greenslopes, Queensland.

The Problem: The customer knocked over the 100+ year old pillar with their car.

The Solution: We removed the original brick footing then dug a 550mm - 600mm deep hole for a the new concrete footing. We made up a reinforcement cage then poured the concrete and let it set. We managed to find the closest possible bricks to match existing, with it being over 100+ years old this is no easy task. Next we laid the bricks with rebar going up through the concrete footing and all the way up the brick pillar. This pillar will now last another 100+ years!

Address

1 GoRenew Street
Brisbane, QLD
4000

Opening Hours

Monday	7am - 5pm
Tuesday	7am - 5pm
Wednesday	7am - 5pm
Thursday	7am - 5pm
Friday	7am - 5pm

Telephone

+61479009611

Website

http://GoRenew.com.au/

Alerts

Be the first to know and let us send you an email when GoRenew posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to GoRenew:

Shortcuts

Address
Telephone
Opening Hours
Alerts
Contact The Business
Claim ownership or report listing

Featured

Armitage Electrical

Want your business to be the top-listed Contractor in Brisbane?