Carpentry MD Home Repair

06/10/2026

Another set done ..time for railing

06/07/2026

https://www.facebook.com/share/1bkeRu9HAd/?mibextid=wwXIfr

Window Flashing Installation Sequence

This technical diagram illustrates the step-by-step process of installing window flashing around a rough opening, moving sequentially from the bottom to the top. Proper flashing installation is crucial in construction to shed water effectively and prevent moisture from penetrating the building envelope. By layering the materials in this specific order, gravity helps direct water away from the structure rather than allowing it to seep into the seams.

Key Components

Sill Flashing (Step 1): The initial blue layer installed at the bottom of the rough opening, designed to turn up at the sides to catch and redirect any downward moisture.

Jamb Flashing (Step 2): Vertical pink elements applied to the sides of the opening that lap directly over the sill flashing to ensure proper water shedding.

Window Unit (Step 3): The actual window frame structure that is securely installed into the prepared opening after the sill and jamb protections are in place.

Head Flashing (Step 4): A rigid yellow top cap that laps over both the side jamb flashing and the top window head fl**ge to block water from above.

Flashing Termination (Step 5): A dark grey sheathing tape applied over the top edge of the head flashing to seal the uppermost seam against the building's exterior wall.

System Overview

The diagram emphasizes a "shingle-style" logic where upper layers consistently overlap lower layers to create a continuous water-resistant barrier. Following this precise five-step sequence ensures that gravity works with the building materials to safely channel water downward and outward. This systematic approach is a fundamental practice for maintaining structural integrity and preventing long-term water damage in residential and commercial construction.

06/05/2026

https://m.facebook.com/story.php?story_fbid=1568094355324158&id=100063708244683&mibextid=wwXIfr

🏠 Do You Know What Renovations Required A Permit And Which Ones Did Not 🏠

Unpermitted work does not disappear when the project is done. It transfers to the next buyer at closing, and that is when it becomes a negotiating problem, a financing problem, or sometimes a deal-ending problem altogether.

The rule of thumb that holds up across most jurisdictions is this: if you are changing the size, structure, or system, you need a permit. Swapping like for like almost never does. A new electrical panel needs a permit. Replacing a single outlet does not. Converting a garage to living space needs a permit. Painting that same garage does not. The line is usually drawn at anything that affects structural integrity, egress, or the home's major systems.

Always ask for the permit history on a home before you close. What you do not know about can absolutely cost you.

06/02/2026

https://www.facebook.com/share/v/1DugicZ3aj/?mibextid=wwXIfr

05/24/2026

https://www.facebook.com/share/v/1GbzKU7Ajd/?mibextid=wwXIfr

05/24/2026

https://www.facebook.com/share/v/1CRbJYntDg/?mibextid=wwXIfr

05/16/2026

My view this morning,Even a small job is a blessing!

05/10/2026

https://www.facebook.com/share/v/1Bt7iqu8Tc/?mibextid=wwXIfr

05/03/2026

Started another remodel and never would have knew the floor was bad from above because of wire mesh,concrete,and tile

05/02/2024