06/14/2023
'THE DUCT CLEANING PROCESS'
1. The HVAC air duct systems’ supply and return side will be “zoned” so our technicians can clean them separately. This can be achieved with the use of zone bags.
2. All supply registers will be closed off to maximize the negative pressure. At that point, we will then clean one duct at a time using this method: All supply ducts will be cleaned using our viper whip system where we snake down 20 plus ft inside every vent. This will disturb and dislodge any dust and debris that is on the main trunk lines.
3. Once all of the supply branches are clean, the primary trunk, as well as plenum drop, will be cleaned by the vacuum with the use of high-pressure air compressed agitation air whipping tools.
4.After the systems’ supply side has been completely cleaned, we will then work on the system’s return side. We will repeat the same step as the supply line and cut an access hole. The vacuum is then connected using the connection collar and will then be turned on.
5. All return ducts will be cleaned using our viper whip system where we snake down 20 plus ft inside every vent. This will disturb and dislodge all dust and debris into the main trunk lines.
6. After all ductwork, including the main trunk lines, have been cleaned, the ductwork will then be sterilized or sanitized.
